Что означает ошибка

This DTC indicates Short circuit between inlet and outlet valve. It belongs to the ABS/EBS brake system group and is classified as excessive current draw or short circuit condition. Reference: code C001495.

Вероятные причины

• Wheel speed sensor or tone ring fault Sensor air gap or mechanical damage EBS/ABS wiring or connector issue Power supply or ground problem Brake modulator/valve or control unit fault Short circuit or excessive current draw Actuator coil/winding fault Harness insulation damage

Что проверить сначала

• Confirm whether the DTC is active or stored and record freeze-frame data. Clear the DTC and repeat the operating conditions that triggered it. Inspect the related connector, pins and harness for damage, corrosion, moisture or poor pin tension. Compare the related live-data value with the expected value and with related sensors. Inspect wheel speed sensor installation, air gap and tone ring condition. Check ABS/EBS power supply, ground and modulator wiring.

Ведомая диагностика

1. Read all active and stored DTCs, freeze-frame data and related live-data parameters. Clear the fault memory and reproduce the complaint under the recorded operating conditions. Visually inspect the component, connector and harness
2. repair obvious damage before deeper testing. Measure power supply, ground and signal/reference voltage under load where applicable. Compare commanded versus actual values and perform actuator/service tests with OEM-level diagnostics. If wiring, power supply and related components test good but the DTC returns, follow the OEM pinpoint test for module/component replacement or software update.