Что означает ошибка

This DTC indicates Feedback voltage measured on the output is higher defined threshold (configurable). Threshold: <0.05*VBAT. It belongs to the SCR/AdBlue/aftertreatment system group and is classified as general fault condition. Reference: code B100417.

Вероятные причины

• Poor DEF/AdBlue quality or contamination DEF dosing pressure/flow problem Crystallized or blocked dosing line/nozzle Faulty NOx/temperature sensor or wiring SCR catalyst efficiency issue OEM-specific fault logic or monitored condition Related wiring/component/module issue Confirm with freeze-frame and live data

Что проверить сначала

• Confirm whether the DTC is active or stored and record freeze-frame data. Clear the DTC and repeat the operating conditions that triggered it. Inspect the related connector, pins and harness for damage, corrosion, moisture or poor pin tension. Compare the related live-data value with the expected value and with related sensors. Check DEF/AdBlue level and quality. Run the OEM DEF dosing/pump and aftertreatment service tests.

Ведомая диагностика

1. Read all active and stored DTCs, freeze-frame data and related live-data parameters. Clear the fault memory and reproduce the complaint under the recorded operating conditions. Visually inspect the component, connector and harness
2. repair obvious damage before deeper testing. Measure power supply, ground and signal/reference voltage under load where applicable. Compare commanded versus actual values and perform actuator/service tests with OEM-level diagnostics. If wiring, power supply and related components test good but the DTC returns, follow the OEM pinpoint test for module/component replacement or software update.