Что означает ошибка
This DTC indicates Data module BCM. It belongs to the ECU/control module group and is classified as erratic, intermittent or incorrect signal. Reference: code ACFE13, SPN ACFE, FMI 13.
Вероятные причины
- Low supply voltage under load Poor ground or relay/fuse issue Moisture/corrosion in ECU connector Incorrect software/calibration Internal control module failure Intermittent contact or vibration-related wiring issue Signal noise/interference Sensor output inconsistent with related data
Что проверить сначала
- Confirm whether the DTC is active or stored and record freeze-frame data. Clear the DTC and repeat the operating conditions that triggered it. Inspect the related connector, pins and harness for damage, corrosion, moisture or poor pin tension. Compare the related live-data value with the expected value and with related sensors. Load-test ECU power supplies and grounds. Check fuses, relays, connector water ingress and software/calibration status.
Ведомая диагностика
- Read all active and stored DTCs, freeze-frame data and related live-data parameters. Clear the fault memory and reproduce the complaint under the recorded operating conditions. Visually inspect the component, connector and harness
- repair obvious damage before deeper testing. Measure power supply, ground and signal/reference voltage under load where applicable. Compare commanded versus actual values and perform actuator/service tests with OEM-level diagnostics. If wiring, power supply and related components test good but the DTC returns, follow the OEM pinpoint test for module/component replacement or software update.
Сервисное примечание
Use OEM service information and wiring diagrams for the exact model, ECU variant and software level. After repair, clear DTCs, perform required adaptations/resets and confirm the fault does not return during a road or service test.