Что означает ошибка

This DTC indicates Sensor pressure, minimum value measurement (short circuit to ground). It belongs to the sensor/actuator circuit group and is classified as voltage below normal, short to ground or low-source condition. Reference: code 1316.

Вероятные причины

• Faulty sensor or actuator Open circuit, short circuit or high resistance Incorrect reference voltage, ground or signal Connector corrosion or pin tension issue Mechanical sticking or installation problem Possible short to ground/low source Low reference voltage or supply drop Open supply circuit or high resistance

Что проверить сначала

• Confirm whether the DTC is active or stored and record freeze-frame data. Clear the DTC and repeat the operating conditions that triggered it. Inspect the related connector, pins and harness for damage, corrosion, moisture or poor pin tension. Compare the related live-data value with the expected value and with related sensors. Verify power supply, ground and signal integrity for the related circuit.

Ведомая диагностика

1. Read all active and stored DTCs, freeze-frame data and related live-data parameters. Clear the fault memory and reproduce the complaint under the recorded operating conditions. Visually inspect the component, connector and harness
2. repair obvious damage before deeper testing. Measure power supply, ground and signal/reference voltage under load where applicable. Compare commanded versus actual values and perform actuator/service tests with OEM-level diagnostics. If wiring, power supply and related components test good but the DTC returns, follow the OEM pinpoint test for module/component replacement or software update.